1

Before You Start

The receiver must be connected to a 12V power source before pairing. The LED indicator on the receiver will confirm each step.

Your kit includes two remotes. Both can be paired to the same receiver - you just pair them one at a time.

2

Choose Your Mode

The number of times you press the Learning Button sets the switching mode. For powering a Starlink Mini on and off, we recommend Latched mode.

Momentary

Stays on while button is held down, turns off when released.

1 press

Toggle

Press a button to turn on, press the SAME button again to turn off. (Single-button on/off.)

2 presses

Latched Recommended

Press the ON button to turn on, press the OFF button to turn off. Uses the two separate buttons on your remote - ideal for the Starlink Mini.

3 presses

Delay (5s / 10s / 15s)

Turns on, then auto switches off after the set delay.

4 / 5 / 6 presses

Tip: after you press the Learning Button 3 times for Latched mode, the receiver LED flashes 3 times and then stays solid green. Solid green confirms you are in the correct mode.

3

Pair Your First Remote

1

Press the Learning Button on the receiver 3 times (for Latched mode). The LED will flash 3 times, then stay solid green to confirm the mode is set.

2

Press the ON button on your first remote. The LED on the receiver will flash 3 times to confirm the ON button is paired.

3

Press the OFF button on your first remote. The LED will flash to confirm the OFF button is paired.

Remote 1 is now paired. Press ON then OFF to make sure it switches the unit on and off.

4

Pair Your Second Remote

1

Press the Learning Button on the receiver 3 times again. The LED will flash 3 times, then stay solid green.

2

Press the ON button on your second remote. The LED on the receiver will flash 3 times to confirm the ON button is paired.

3

Press the OFF button on your second remote. The LED will flash to confirm the OFF button is paired.

Both remotes are now paired. Either remote will switch the Starlink Mini on or off.

R

Reset / Clear All Paired Remotes

If you need to start fresh or are having trouble pairing, you can clear all paired remotes from the receiver.

1

Press and hold the Learning Button on the receiver for 8 to 10 seconds, until the LED flashes. (No need to time it exactly - just hold for a good count and watch for the flash.)

2

The LED will flash and then turn off, confirming the receiver has been wiped.

3

All previously paired remotes AND the mode setting are now cleared. Repeat Steps 2 to 4 above to re-select your mode (3 presses for Latched) and re-pair your remotes.

?

Troubleshooting

Only one remote works?

The most common reason is that only one remote was paired, or only one button on a remote was paired. Each remote must be paired separately, and on each remote you pair BOTH the ON and the OFF button. Repeat the full learning sequence in Steps 3 and 4.

LED not flashing during pairing?

Check the receiver is getting 12V power. The LED must flash to confirm each step.

Behaviour seems wrong? (e.g. the ON button switches the unit off when pressed again, or both buttons do the same thing)

You have most likely set Toggle mode by mistake. Pressing the Learning Button 2 times sets Toggle (where a single button flips on and off) - so when you press the ON button a second time to test it, it powers the unit DOWN. That is not a fault, it is the wrong mode. Clear all remotes using the Reset steps, then re-pair using 3 presses for Latched mode. In Latched mode the ON button only switches on and the OFF button only switches off. After 3 presses the LED should flash 3 times and then stay solid green.

Wireless Remote Switch Setup

Wireless Remote Control Switch

Country/region